Geeks3D Forums

GeeXLab => GeeXLab - english forum => Topic started by: stakov999 on March 08, 2018, 06:37:29 PM

Title: Luajit for Linux
Post by: stakov999 on March 08, 2018, 06:37:29 PM
Hello all,

Did anyone tried to run GeexLab (specially Imgui functions) with luajit rather than lua5.3 ?
Is it even possible ?

Thank you in advance
Best regards

stakov
Title: Re: Luajit for Linux
Post by: stakov999 on March 09, 2018, 09:51:35 AM
I didn't mention : running on linux x64
Title: Re: Luajit for Linux
Post by: JeGX on March 09, 2018, 01:13:25 PM
I only tested GeeXLab + ImGui + LuaJIT on Windows and it works fine!

LuaJIT is currently supported by the Windows version of GeeXLab only. But I will try to add this support to Linux (and macOS) as soon as possible.
Title: Re: Luajit for Linux
Post by: stakov999 on March 09, 2018, 03:03:44 PM
Thank you !
Let met know when you do it
Regards
Title: Re: Luajit for Linux
Post by: JeGX on April 24, 2018, 08:56:30 PM
LuaJIT is available in GeeXLab 0.22.1 for Linux:
http://www.geeks3d.com/hacklab/20180419/geexlab-0-22-1-released-for-all-platforms/

and here is how to enable LuaJIT in GeeXLab:
http://www.geeks3d.com/hacklab/20180423/how-to-enable-luajit-in-geexlab/
Title: Re: Luajit for Linux
Post by: JeGX on May 04, 2018, 04:29:34 PM
LuaJIT support has been added to Raspberry Pi and Tinker Board in GeeXLab 0.24+:

http://www.geeks3d.com/hacklab/20180504/geexlab-0-24-0-released-for-windows-linux-macos-raspberry-pi-and-tinker-board/