Geeks3D Forums

Geeks3D.com | GeeXLab | Softwares | Reviews | Downloads | Shader Lib 


News:Rendering 3D Graphics on a 32×32 RGB LED Matrix Display with a Raspberry Pi and GeeXLab

Issue with CF 6950s and Kmark

(Read 12946 times)

0 Members and 1 Guest are viewing this topic.



Iredeus

  • Newbie
  • *
  • *
  • Posts: 4
Hey everyone, when I try to run kmark with my 6950s I get weird flickering rectangles on the ground, but I can play crysis 2 and bf 3 without issues. Is anyone else experiencing this issue?



JeGX

  • Global Moderator
  • Hero Member
  • *****
  • *
  • Posts: 1594
Do you have the problem with one Radeon (CF disabled)?
I must say that I didn't re-tested KMark with Crossfire recently...

Iredeus

  • Newbie
  • *
  • *
  • Posts: 4
No I haven't done that yet, I will and ill post the result.

Iredeus

  • Newbie
  • *
  • *
  • Posts: 4
It still did it, it doesn't do it in anything else though.... most likely a driver issue maybe?

JeGX

  • Global Moderator
  • Hero Member
  • *****
  • *
  • Posts: 1594
I will test KMark with a HD 6970 asap (during the update of Kombustor). Maybe, could you please post a screenshot of the issue if you can catch it.

Iredeus

  • Newbie
  • *
  • *
  • Posts: 4
Okay, I reran KMark, I used the 720P mode but it does it for all modes. I also noticed that the clock on my first card was still in the low power state. I didn't notice it before, so it seems that crossfire isn't wroking properly, which makes me think even more that it may be a driver issue. I have cata 12.2 previews installed, and not the official release drivers because they were causing me other issues; and I have CAP 12.2 v 1 installled.



EDIT: Never mind, it shows the right clocks in 1080p mode, its just the 720p that doesn't show the right clocks. Regardless though, I have the same flickering issue no matter the settings I use.
Last Edit: March 24, 2012, 10:20:35 PM by Iredeus