Author Topic: Luajit for Linux  (Read 1336 times)



0 Members and 1 Guest are viewing this topic.

stakov999

  • Newbie
  • *
  • Posts: 8
    • View Profile
Luajit for Linux
« on: March 08, 2018, 06:37:29 PM »
Hello all,

Did anyone tried to run GeexLab (specially Imgui functions) with luajit rather than lua5.3 ?
Is it even possible ?

Thank you in advance
Best regards

stakov

stakov999

  • Newbie
  • *
  • Posts: 8
    • View Profile
Re: Luajit for Linux
« Reply #1 on: March 09, 2018, 09:51:35 AM »
I didn't mention : running on linux x64

JeGX

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1511
    • View Profile
    • Geeks3D.com
Re: Luajit for Linux
« Reply #2 on: March 09, 2018, 01:13:25 PM »
I only tested GeeXLab + ImGui + LuaJIT on Windows and it works fine!

LuaJIT is currently supported by the Windows version of GeeXLab only. But I will try to add this support to Linux (and macOS) as soon as possible.

stakov999

  • Newbie
  • *
  • Posts: 8
    • View Profile
Re: Luajit for Linux
« Reply #3 on: March 09, 2018, 03:03:44 PM »
Thank you !
Let met know when you do it
Regards

JeGX

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1511
    • View Profile
    • Geeks3D.com
Re: Luajit for Linux
« Reply #4 on: April 24, 2018, 08:56:30 PM »

JeGX

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1511
    • View Profile
    • Geeks3D.com
Re: Luajit for Linux
« Reply #5 on: May 04, 2018, 04:29:34 PM »
LuaJIT support has been added to Raspberry Pi and Tinker Board in GeeXLab 0.24+:

http://www.geeks3d.com/hacklab/20180504/geexlab-0-24-0-released-for-windows-linux-macos-raspberry-pi-and-tinker-board/